Life in the Bus Lane

2006 Updates

Click here for later entries.

Progress!

27/11/06: Slow News Day

Not much visible progress to report. Read more....


Progress!

26/10/06: Oops

Progress has been slow, not to mention in the wrong direction! Read more....


10/10/06: Tanks A Lot

By way of a bonus I have come across a photo of Midland Red‘s AEC Mammoth Major tanker. I have added this to the page on the EFE model.


Progress!

28/09/06: Below Decks

Progress has been mostly ‘below decks’ on the roundabout board... Read more....


Progress!

28/08/06: Tweaking Time

In the last month I have added the railway tracks to the first two baseboards, wired the tracks and road junctions and extensively tested and tweaked the roadway. Read more....


Progress!

28/07/06: Round and Round

Over the last month the guide wire has been laid on the first two boards... Read more....


Mock up

28/06/06 Bottom‘s Up!

Construction has at last started on the baseboards for Redhill. Read more....


Towards Station Road

12/06/06 First Steps...

Having got the plywood that will form the roadways I started marking out the course of the guide wire according to the plan. Read more....


Faller vehicle circuit

26/05/06 Inside the machine...

A number of people have asked for details of the circuit inside the Faller vehicles, so here it is.


I have a cunning plan

11/04/06 I Have A Cunning Plan...

...well, I have had more of them than I care to contemplate. More...


Unreasonable Expectations

20/03/06 Unreasonable Expectations

I have a crisis with my DMU...


What is the Faller Car System?

06/03/06 New Readers Begin Here...

What is the Faller Car System?


Hall Effect Switch

21/02/06 Deck The Halls...

What can Hall Effect Switches do for you?


Albert Wright's layout

01/02/06 Albert Wright’s Faller Layout

A few pictures of this layout....


D9 with illuminated advert panel

17/01/06 The Brummie Routemaster...

But so much better! The wonderful D9....


One I prepared earlier

08/01/06 Here‘s one I prepared earlier...

Back in 2000 I prepared an article for Model Buses on converting a Faller bus to fit under an EFE body. It is still valid today so, here it is....